Controls the headphone mix. The first three knobs will control the first three parameters for that effect. When the track is stopped, the jog wheel seeks forward and backward in the corresponding track. These are located on the back of the unit. Holding shift while pressing it toggles Quantize on and off for that deck.

Uploader: Shakalkree
Date Added: 4 April 2015
File Size: 67.90 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 21700
Price: Free* [*Free Regsitration Required]

This is expected to change in 2. Documentation for the mapping is available on the Mixco website. Getting LEDs to work with old mappings pre Holding the corresponding deck’s m-audio xponent button while pressing the Big Minus button will do a rolling reverse censor modeand will resume play at the point the track would have been if the Big Minus had never been pressed.

This behavior can be switched to behave as a master-out meter instead by setting the value of MaudioXponent. Releasing the brake before the track has stopped will resume playing, while holding it until the track has stopped completely will leave the track paused.

If the buttons no longer pulse brightly and fade down when you press them, then the Xponent is in the correct mode for use with Mixxx. This is a hardware control, and changes will not be reflected in the Mixxx UI. The latency meter seems to run a bit higher than it did under ASIO, so keep this in mind, m-audio xponent test both setups with your own system to see how they compare.


The latest version can be found in this Forum Post. Due m-audio xponent limitations in the 2.

M-Audio Torq Xponent

This device has been discontinued. All the way to the right sends m-audio xponent the main output to the headphones 28 Headphone Volume Controls the volume of the headphones. The flashing behavior can be customized by setting the MaudioXponent. Displays the current output level for the corresponding deck. Once an effect has the focus, pressing the button again will toggle it on and off.

The upper numbered buttons set or activate m-audio xponent. This preference can be set in the config section of the M-Audio-Xponent-Advanced-scripts.

M Audio Torq | eBay

m-audio xponent When the track is stopped, the jog wheel seeks m-audio xponent and backward in the corresponding track. Momentarily pulls the cross-fader to the center position while pressed. This mapping expands on the stock 2. The default mode can be changed in the config section of the M-Audio-Xponent-Advanced-scripts.

The 1, 2, 4, and 8 buttons behave as normal, starting a loop of X beats at the current position. Holding shift while pressing either button will align the beatgrid to the current position.


When scratch mode is xponetn, moving the wheel by touching the top surface will scratch, while moving the wheel by touching the outer ring will act as a normal m-audio xponent. Any additional effect parameters beyond three will have to be controlled from the Mixx UI.

M Audio Torq

M-audio xponent the progress through the corresponding track. Flashes on each beat of the corresponding track. This documentation should be considered preliminary and m-audko to change. Lights No need to hold down any keys, but see the note for Windows users above.

Alters the behavior of certain controls.

The script was written with the Mixco mapping framework. Selects which track s are heard through the headphone output This mapping has two PFL m-audio xponent. Pressing the same button again while looping will exit that loop. These MIDI inputs are not used in this mapping.